PCB Heaven

General Category => General Discussion => Topic started by: sgc3000000 on December 21, 2015, 18:24:42 PM

Title: Reverse engineering LCD Screen
Post by: sgc3000000 on December 21, 2015, 18:24:42 PM
Hi there,

I am new to these forums and new to electronics however I have a problem that I think everyone here would be able to help with:

I need to convert the signal sent from the unit to the LCD panel into a standard component video signal (HDMI if this is not possible). Products that do this in reverse are abundant yet I have not found one that does this yet.

The purpose of this product is to duplicate exactly what is being show on the unit (Pioneer SPH-DA120 car stereo) on annother screen.

The connector that the LCD screen uses is a 60 pin FPC connector with 0.5mm spacing. This would effectively have to be split in two to allow for the second output. All technical specifications about the LCD screen signal can be found here:

http://panelone.net/en/6-2-inch/CPT_CLAA062LA02CW_6.2_inch-datasheet


Thanks for the help guys !
Title: Re: Reverse engineering LCD Screen
Post by: kam on December 28, 2015, 18:37:00 PM
I don't want to disappoint you but what you ask requires a lot of skills.