Home     Contact     Forum     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science     RSS     Terms of services     Privacy policy  
   
 Home     Forum     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science   

Author Topic: who the circuit of fluorescent lamp works?  (Read 3709 times)

0 Members and 1 Guest are viewing this topic.

johniee

  • Newbie
  • *
  • Posts: 14
who the circuit of fluorescent lamp works?
« on: May 12, 2011, 00:22:53 AM »
have anyone how the circuit of this lamp works??? The sure thing is that the circuit replace the starter and choke. Maybe it convert the frequency and  voltage (boost). Let's do reverse engineering.. :D 

kam

  • Administrator
  • Hero Member
  • *****
  • Posts: 1849
Re: who the circuit of fluorescent lamp works?
« Reply #1 on: May 12, 2011, 13:46:08 PM »
you mean the electronic circuit, or the classic ballast-stater? I think they both work on the same principle. Do you have a circuit in mind?

johniee

  • Newbie
  • *
  • Posts: 14
Re: who the circuit of fluorescent lamp works?
« Reply #2 on: May 12, 2011, 15:02:57 PM »
yes i mean the electronic circuit, the integrated one. I think that it maybe have different from the classic one ballast-stater , because it is less tiring at eye and also exists fluorescent lamp with 'warm' or 'cold' light. Also i was i looking a burned  one and i saw many diodes, possibly a ac-dc converter.. that i have in mind for now.. 

kam

  • Administrator
  • Hero Member
  • *****
  • Posts: 1849
Re: who the circuit of fluorescent lamp works?
« Reply #3 on: May 13, 2011, 09:22:01 AM »
these kind of lamps operate with HID (High Intensity Discharge) technique. An arc is produce between two electrodes (left - right side) and this arc can be sustained infinite. To make the arc, a high voltage must be applied. This is where the ballast comes. The normal ballast uses the 50-60Hz of the mains power to generate high voltage through electromagnetism. Electronic ballasts have ICs to generate high frequency pulses (around 30 Khz) and drive them to a ferrite core coil to get the high voltage.

I do not know much about the circuit, but i suppose that it has an AC-DC converter to get the DC power required for the chips to operate, and then a DC-AC converter to perform a voltage intensifier. Something like an AC inverter.

Using electronic ballasts generate better light because of the high frequency (like 100 Hz monitor is better than 50 Hz).

johniee

  • Newbie
  • *
  • Posts: 14
Re: who the circuit of fluorescent lamp works?
« Reply #4 on: May 14, 2011, 14:53:11 PM »
thanks! yes it must be an AC inverter on the circuit, to adjust the frequency to produce better  light.