Home     Contact     Forum     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science     RSS     Terms of services     Privacy policy  
   
 Home     Forum     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science   

Author Topic: WiFi robot  (Read 11984 times)

0 Members and 1 Guest are viewing this topic.

methos

  • Guest
Re: WiFi robot
« Reply #15 on: June 01, 2008, 14:26:41 PM »
Check this out! Great!!!

Radio Data Transceiver - 433MHz

Andre

  • Guest
Re: WiFi robot
« Reply #16 on: June 01, 2008, 17:18:26 PM »
Yes, that's great!

But this leaves the imagination free...  ;)

kam

  • Administrator
  • Hero Member
  • *****
  • Posts: 1849
Re: WiFi robot
« Reply #17 on: June 04, 2008, 19:22:15 PM »
That's the main idea of this site. IMAGINATION

Mercury

  • Guest
Re: WiFi robot
« Reply #18 on: August 06, 2008, 02:35:26 AM »
I was surfing the ebay when i came across some really really great gadgets. Micro transeivers, 300mt open field, 100 mt indoors transmision, RF 3 bands with encoded signal ready for use, antenna not included  ;)

And i think it costed less than 10 dollars each. It is ready mounted on a small PCB. Check sureelectronics

kam

  • Administrator
  • Hero Member
  • *****
  • Posts: 1849
Re: WiFi robot
« Reply #19 on: August 07, 2008, 13:56:16 PM »
I know what you have seen, i think  ;D

It has 4 pins, power, data and antenna. Is that so?

This is great but i have not found any documentation for this.   >:(

Mercury

  • Guest
Re: WiFi robot
« Reply #20 on: August 21, 2008, 20:32:27 PM »
Well actually, sorry for my previous post. It was not sureelectronics. Sorry.

I searched again and cannot find the same as i did before. But i found a lot others. Actually, it has become very common. And there is not an actuall need to use the chip itself instead a ready PCB transiever.  ;)

Ryan27

  • Guest
Re: WiFi robot
« Reply #21 on: December 09, 2011, 12:45:08 PM »
Hello then show you a robot which is controlled by visual basic
through a wifi network with WINSOC.

The project is a Visual Basic 6.0 application I can connect the
Arduino wifi module to a home wireless network, I can control with visual
my robot to see what else I can catch the robot sensors, in
this case an accelerometer but you can view data
sharp sensors.
The interface is very simple to have an EditText IP address, a
for the port and the switching on and off button.
Tex in the edit that says "Put Mouse Pointer Here" puts the pointer
mouse and arrow keys can now control your robot if
want self, there is a corresponding button for this and the other for
return it to the control mode.

Hope you like it


Thanks.   :)  :)  :)