Home     Contact     Forum     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science     RSS     Terms of services     Privacy policy  
   
 Home     Forum     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science   

Author Topic: Eagle auto route  (Read 8158 times)

0 Members and 1 Guest are viewing this topic.

Elf

  • Guest
Eagle auto route
« on: April 03, 2008, 23:00:57 PM »
I use eagle for the first time and i want to make a pcb.

I have the schematic and i run auto route. The a/route does not finish 100%. There are some jumpers missing. Can eagle be configured to make some jumpers automatically? Or do i have to make them my self?

Supernova

  • Moderator
  • Full Member
  • *****
  • Posts: 149
Re: Eagle auto route
« Reply #1 on: April 04, 2008, 18:25:04 PM »
No there is not  :-\

FelIX

  • Guest
Re: Eagle auto route
« Reply #2 on: April 04, 2008, 20:46:35 PM »
If you want a single layer pcb, then make a 2 layer pcb and just make bridges for the 2nd layer

manley_V

  • Guest
Re: Eagle auto route
« Reply #3 on: April 04, 2008, 22:11:08 PM »
I had never thought of it.  ;D ;D ;D

Erkeli

  • Guest
Re: Eagle auto route
« Reply #4 on: April 12, 2008, 00:57:14 AM »
I do not like the results of this. I tested it. The bridges go over parts and in general, this is not a nice way.

kam

  • Administrator
  • Hero Member
  • *****
  • Posts: 1849
Re: Eagle auto route
« Reply #5 on: April 13, 2008, 14:59:23 PM »
Find which lines should be jimt using bridges and put some connectors in the schematic. Now instead of the connectors put the bridges.