Home     Contact     Forum     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science     RSS     Terms of services     Privacy policy  
   
 Home     Forum     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science   

Author Topic: Bench drill press modification  (Read 4231 times)

0 Members and 1 Guest are viewing this topic.

phpenguin

  • Newbie
  • *
  • Posts: 23
Bench drill press modification
« on: November 12, 2014, 13:34:57 PM »
I bought a used foot switch from a scrapyard and installed it on my drill press.



After few hours of test run, I replaced all the tape connections and organized wires to finish the modification.






kam

  • Administrator
  • Hero Member
  • *****
  • Posts: 1849
Re: Bench drill press modification
« Reply #1 on: November 12, 2014, 22:27:36 PM »
phpenguin is back!   ;)

phpenguin

  • Newbie
  • *
  • Posts: 23
Re: Bench drill press modification
« Reply #2 on: November 14, 2014, 07:35:24 AM »
Thanks Kam.

That one is like a kid's play compared to my Kossel Mini 3D Printer project.
It has been about three months since I started the project from scratch.



I might ask for advises related to electronic stuff soon.


kam

  • Administrator
  • Hero Member
  • *****
  • Posts: 1849
Re: Bench drill press modification
« Reply #3 on: November 14, 2014, 23:39:15 PM »
dude you're on to something here  8) Make videos! And of course ask your questions  ;)

cheerio

  • Sr. Member
  • ****
  • Posts: 306
Re: Bench drill press modification
« Reply #4 on: November 16, 2014, 14:29:19 PM »
oh man that printer is sexy

kam

  • Administrator
  • Hero Member
  • *****
  • Posts: 1849
Re: Bench drill press modification
« Reply #5 on: November 17, 2014, 16:35:39 PM »
that geometry calculation to get into position just blows my mind!