Home     Contact     Forum     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science     RSS     Terms of services     Privacy policy  
   
 Home     Forum     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science   

Author Topic: PWM led driver for 60 3mm led or 3528 smd leds 17.5 to 9v output led array  (Read 4798 times)

0 Members and 1 Guest are viewing this topic.

dhandrei

  • Cadet
  • Posts: 1
Hello for all!!!

Dear,
I need to do a PWM led driver controller for a led array with 43 blue led and 13 3mm red led in the same pcb.
I found millions of circuit about this on the word wide web, but I'm not technician, I'm a electronic enthusiast, in this forum I found this led driver http://www.pcbheaven.com/circuitpages/LED_PWM_Dimmer/
The problem is that my car use 15.5v when the engine is off and 17.5v when the engine is on.
I wish make this pwm circuit for my AC Commander with and without dimmer (trimpot) in separated pcb, for this PCB I will need 43 leds 3mm, 20mA 3.3v and 13 red leds 3mm 20mA 2.2v or 3528 smd led.
In the CircuitWizard I made this circuit, but the voltage of the 555 output pin is 17.5v and this voltage are going direct to the leds array. What is the component I can replace to send 9v to the led array?

Some one can help me?

I made this circuit, is correct?



for the only PWM what I need remove and replace?


Thanks to all, for the help



kam

  • Administrator
  • Hero Member
  • *****
  • Posts: 1849
Hello,
as far as i can tell, what you need is a way to drop your car's voltage down to 12V. the 555 cannot operate at higher than 15V.
So, I suggest that you use the 7812 IC. It can provide up to 1A of current (with a good heat sink) which is perfect for you since your LED strips will draw as much as 420mA. use this chip to get the 12V and then get all the +V of the circuit out of this chip instead of your bat.
A plus is that the brightness of the LEDs and the current will always remain stable since the chip will always provide 12V regardless of the car's voltage.
Remember to use a good heatsink for the 7812 as it may be required to dissipate as much as 3 Watts of heat

at 600mA current and 17V input voltage it is
(17-12) X 0.6 = 3Watt