Home     Contact     Forum     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science     RSS     Terms of services     Privacy policy  
   
 Home     Forum     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science   

Author Topic: A simple question for CNC PCb  (Read 4679 times)

0 Members and 1 Guest are viewing this topic.

karl_folker

  • Guest
A simple question for CNC PCb
« on: May 05, 2008, 21:00:04 PM »
A simple question for this. I have a software for make a pcb and a schematic. Then kan this to a CNC send and make the pcb.

But how kan the cnc make the pcb? The holes understand i. I understand not the etching. How can this do it?

Andre

  • Guest
Re: A simple question for CNC PCb
« Reply #1 on: June 01, 2008, 17:22:59 PM »
Well karl, it really does the same as etching but with a router. A small router is used to remove the copper from the surface. It is a little 'stoneage' method, a little bit brutal but almost 100% success for even a first time maker. All you need is a CNC machine...  :D ;D ;D

spic0m

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 841
Re: A simple question for CNC PCb
« Reply #2 on: June 03, 2008, 11:55:19 AM »
You can even build a cnc for this reasons, there's plenty of sites giving schematics and stuff on how to do it.

http://www.storm.ca/~rheslip/cnc.htm
« Last Edit: June 03, 2008, 12:40:05 PM by spic0m »

Mosquito

  • Guest
Re: A simple question for CNC PCb
« Reply #3 on: June 04, 2008, 19:34:02 PM »
lol very good