3 phase motor megger testing

[Greg]

I have a 3 phase motor   When testing with a megger do you only test from each winding to ground.
When I do a ohm meter test of the 6 wires I get a reading wirer  green 1&2.  9.7ohm       White  3&4.  9.7 ohm          Yellow  5&6   9.7 ohm readings .
This is the order in witch they wer connected to the terminal block.
When I connect any black wirer or white wirer in any order I get a ohm reading between 17 and 10 ohm  black to black or white to white black to white.
I do not under stand this layout.
Are all the wind endings going inside.
The windings do not go to earth.
Grer