Home     Contact     Forum     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science     RSS     Terms of services     Privacy policy  
   
 Home     Forum     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science   

Author Topic: Hello, New to PCB  (Read 4164 times)

0 Members and 1 Guest are viewing this topic.

millie_norton

  • Guest
Hello, New to PCB
« on: August 06, 2008, 10:57:58 AM »
Hello forum,

I am new to PCB making and to PCB Heaven forum also.
I would like to know, what is a best method to start making PCB for first time? Is it hard? And can i have some help how to make them?

Thank you  ;)

spic0m

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 841
Re: Hello, New to PCB
« Reply #1 on: August 06, 2008, 12:55:06 PM »
Welcome to our forums!
Reading the theory pages would be a good start, and then pointing out questions untill you decide to make the step to build one.

SiEger

  • Guest
Re: Hello, New to PCB
« Reply #2 on: August 07, 2008, 12:12:58 PM »

wangting8383

  • Guest
Re: Hello, New to PCB
« Reply #3 on: December 18, 2009, 12:04:11 PM »
I am a newman to pcbheaven forum also.

hope to make friends with all of you from pcb line.

kam

  • Administrator
  • Hero Member
  • *****
  • Posts: 1849
Re: Hello, New to PCB
« Reply #4 on: December 18, 2009, 17:18:18 PM »
Welcome all,

I would suggest the direct draw method with a permanent maker, along with self-transfer.

gdszyl

  • Guest
Re: Hello, New to PCB
« Reply #5 on: December 23, 2009, 05:03:50 AM »
contact with ylcode.com before your making few by youself

MrDEB

  • Guest
Re: Hello, New to PCB
« Reply #6 on: May 21, 2010, 14:06:09 PM »
I found the Sharpie pen using the ultra fine point works but only for very simple designs.
Next step up I would recomment the toner transfer method
http://www.fullnet.com/~tomg/gooteepc.htm
http://www.pulsarprofx.com/
this one for drill bits A #58 and # 56 are about the only ones I use.http://www.widgetsupply.com/page/WS/CTGY/dremelhttp:
For drawing I use express PCB (free download)
Very easy to learn.