Home     Contact     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science     RSS     Terms of services     Privacy policy  
   
 Home      Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science   


<< Back to INDEX

Make Your Own FM Vertical Sleeve Coax Antenna [DIY]
posted June 6 2014 10:47.18 by spic0m




If your looking to make a fairly simple vertical FM antenna(Transmit or Receive), then this video may be for you. All that is required is some coax(preferably 50 ohm with copper shielding, a small diameter brass/copper tube, solder and rosin flux, heat shrink tubing, and an RF connector of your choice. Using a SWR meter would also be extremely useful for very precise tuning, but not mandatory.



[Link: electronicsNmore]
 
Share



You might also like...


USB Oscilloscope with Signal generator [Project]

Pickit 2 clone The Universal Microchip PIC Programmer /Debugger [Project]

Basic LASER Security System [Project]

This trash bin moves autonomously to catch your garnish [Tech]

Controlling the speed and direction of a DC motor with FPGA [Project]

Interface the Analog Discovery USB oscilloscope with LabVIEW

One-Chip Sound Player [Project]

Wireless Controlled Robotic Hand [Project]


<< Back to INDEX



Comments

  Name

  Email (shall not be published)

  Website

Notify me of new posts via email


Write your comments below:
BEFORE you post a comment:You are welcome to comment for corrections and suggestions on this page. But if you have questions please use the forum instead to post it. Thank you.


      

No comment yet...

Be the first to comment on this page!












 Contact     Forum     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science     RSS   

Site design: Giorgos Lazaridis
© Copyright 2008
Please read the Terms of services and the Privacy policy