Home     Contact     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science     RSS     Terms of services     Privacy policy  
   
 Home      Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science   


<< Back to INDEX

Explaining how an OP-Amp Low-Pass Filter works [Theory]
posted September 17 2014 14:48.41 by Giorgos Lazaridis




Here is a very good explanation on how the OP-Amp low-pass filter works. Stan Gibilisco starts with a non-inverting amplifier OP-Amp circuit and then adds the one extra capacitor to convert it into a low-pass filter, explaining why this happens and how it works.



[Link: Stan Gibilisco Stan Gibilisco]
 
Share



You might also like...


ATTENTION! Bad fat exists in partially hydrogenated foods [Health]

How Big Is The Universe? [Education]

Some very common misconceptions in Physics [Science]

What are the internet packets and what do they serve [Internet]

The greatest discovery of modern science: 99.9% we discovered The Gods' Particle into CERN [Science]

How common is your birthday? [Infographic]

Analysing 433 Mhz transmitters with RTL-SDR [Education]

This is how the monetary system works - and its no funny [Economics]


<< Back to INDEX



Comments

  Name

  Email (shall not be published)

  Website

Notify me of new posts via email


Write your comments below:
BEFORE you post a comment:You are welcome to comment for corrections and suggestions on this page. But if you have questions please use the forum instead to post it. Thank you.


      

No comment yet...

Be the first to comment on this page!












 Contact     Forum     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science     RSS   

Site design: Giorgos Lazaridis
© Copyright 2008
Please read the Terms of services and the Privacy policy