Home     Contact     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science     RSS     Terms of services     Privacy policy  
   
 Home      Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science   


<< Back to INDEX

Why Flyback Diode is Important when Switching Inductive Loads [Theory]
posted October 8 2014 17:18.21 by Giorgos Lazaridis




Get any circuit with a transistor switching an inductive load. Chances are that you will see a reverse-biased diode across the load. This is called a flyback or catch diode (or any other way). The purpose of this diode is to give current a way to run back to the source when the inductive charge is about to discharge. Watch the following video with a detailed and fine explanation:



[Link]
 
Share



You might also like...


How tall can a mountain be on Earth? [Geology]

Boiling water at mountain Everest [Experiment]

The [im]possible puzzle [Riddles]

How MEMS sensors (like your smart phone accelerometer) works

The story of the gunpowder and how it works [Chemistry]

Raspberry Pi 2 Xenon flash problem explained and tested in the lab

Betelgeuse - A neighbor star near its explosive death [Astronomy]

Methods to Protect your Circuits from Backwards Voltage [Circuit]


<< Back to INDEX



Comments

  Name

  Email (shall not be published)

  Website

Notify me of new posts via email


Write your comments below:
BEFORE you post a comment:You are welcome to comment for corrections and suggestions on this page. But if you have questions please use the forum instead to post it. Thank you.


      

No comment yet...

Be the first to comment on this page!












 Contact     Forum     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science     RSS   

Site design: Giorgos Lazaridis
© Copyright 2008
Please read the Terms of services and the Privacy policy