Home     Contact     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science     RSS     Terms of services     Privacy policy  
   
 Home      Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science   


<< Back to INDEX

Macgyver SMD Soldering Iron Adaptor [DIY]
posted May 21 2014 12:17.45 by spic0m




Rupert Hirst at Run Away Brainz came up with this small but utterly useful hack for his soldering iron.

"Surface mount component removal can often be tricky. With a little thought, and a piece of copper wire, small components can now be safely and cleanly removed, without damage to either the component or PCB tracks. In the following video I show you how to make an quick and simple adaptor for your soldering iron. Macgyver would be proud!"



[Link: Run Away Brainz]
 
Share



You might also like...


Solar powered Stirling engine runs at 1000rpm [Project]

Web-Radio with Arduino [Project]

Wearable Peltier Wristband Harvests Body Heat to Charge a Phone [Project]

The treasure hunt game with an Arduino twist

This trash bin moves autonomously to catch your garnish [Tech]

DC motor speed and direction control using arduino

LM386 Low Voltage Audio Power Amplifier [Project]

TinyPrime [Project]


<< Back to INDEX



Comments

  Name

  Email (shall not be published)

  Website

Notify me of new posts via email


Write your comments below:
BEFORE you post a comment:You are welcome to comment for corrections and suggestions on this page. But if you have questions please use the forum instead to post it. Thank you.


      

No comment yet...

Be the first to comment on this page!












 Contact     Forum     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science     RSS   

Site design: Giorgos Lazaridis
© Copyright 2008
Please read the Terms of services and the Privacy policy