Home     Contact     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science     RSS     Terms of services     Privacy policy  
 Home      Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science   

<< Back to INDEX

3D Jello printer [Project]
posted June 10 2014 10:43.36 by spic0m

A funny, but fully operational, 3D printer made from old CD-ROMS and a syringe, the needle applies the "printing fluid" in small plastic shots.
Content of the shot glasses is jello (duh), printing fluid is a mixture of banana liquor, food coloring and starch treated in microwave oven to make it less viscose.

[Link: Sprites Mods]

You might also like...

Arduino, GPS, and Remote-Controlled Aircraft [Project]

DIY Wooden Work Light is Bright and Brilliant [Project]

What's hidden inside this Chinese USB stick [Surprise]

Etching your Own PCBs Simplified [Tutorial]

This DIY Aluminum 3D Printer may kickstart your creativity [Project]

Replacing the room lighting with LEDs [Project]

PiPhone - A Raspberry Pi based Smartphone [Project]

Raspberry Pi Temperature & Humidity Network Monitor [Project]

<< Back to INDEX



  Email (shall not be published)


Notify me of new posts via email

Write your comments below:
BEFORE you post a comment:You are welcome to comment for corrections and suggestions on this page. But if you have questions please use the forum instead to post it. Thank you.


No comment yet...

Be the first to comment on this page!

 Contact     Forum     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science     RSS   

Site design: Giorgos Lazaridis
© Copyright 2008
Please read the Terms of services and the Privacy policy