Home     Contact     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science     RSS     Terms of services     Privacy policy  
   
 Home      Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science   


<< Back to INDEX

Automatic Ultrasonic Trash Can Lid Opener [Project]
posted September 9 2014 8:31.50 by Giorgos Lazaridis




This project requires some tweaking as far as the electronics is concerned, and definitely some basketball skills as far as the operator is concerned. What this guys has done is he made an ultrasonic range detection device and placed it near the lid of a trash can. Then he used an arduino board to control a servo. This servo in turn is placed so that it can open the lid of the trash can.



[Link: tinkernut]
 
Share



You might also like...


A Website-Down-Alarm lets you know the bad news first

Liquid Heat Dissipation using Mineral Oil [Project]

MCP1640 - 0.35V High Efficiency Boost Regulator [Chip Ideas]

Automatic Ultrasonic Trash Can Lid Opener [Project]

Wearable Peltier Wristband Harvests Body Heat to Charge a Phone [Project]

Actually, this DIY walking bot is cute!

5A 30W Dummy Load [Project]

8x8x8 LED Cube with timelapse make-of video [Project]


<< Back to INDEX



Comments

  Name

  Email (shall not be published)

  Website

Notify me of new posts via email


Write your comments below:
BEFORE you post a comment:You are welcome to comment for corrections and suggestions on this page. But if you have questions please use the forum instead to post it. Thank you.


      

No comment yet...

Be the first to comment on this page!












 Contact     Forum     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science     RSS   

Site design: Giorgos Lazaridis
© Copyright 2008
Please read the Terms of services and the Privacy policy