Home     Contact     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science     RSS     Terms of services     Privacy policy  
   
 Home      Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science   


<< Back to INDEX

How to remove the epoxy package of the IC Chips [Chemistry]
posted August 13 2012 15:36.24 by Giorgos Lazaridis




It is easier than i expected... Here is a simple to follow How-To guide from Ben Krasnow. What he did is he routed the raw part of the chip with a CNC router, and then he used nitric acid to dissolve the rest of the epoxy. To speed up the reaction he increased the temperature to some 100 degrees C. The results are very good.



[Link: Ben Krasnow]
 
Share



You might also like...


Use this Open Source Lib to play Chess with Arduino [Project]

Drum implosion experiment on steroids [Physics]

CNC Pen Plotter from Computer Trash (mainly) and Arduino [Project]

Hacking a Thermostat to get Remote Temperature Readings [Hack]

PIC Programmable USB button

Find out how your voice sounds to others [Lifehacks]

Soldering through-hole components tips [Video]

Using the Tessel micro to water plants with Javascript over WiFi!


<< Back to INDEX



Comments

  Name

  Email (shall not be published)

  Website

Notify me of new posts via email


Write your comments below:
BEFORE you post a comment:You are welcome to comment for corrections and suggestions on this page. But if you have questions please use the forum instead to post it. Thank you.


      

No comment yet...

Be the first to comment on this page!












 Contact     Forum     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science     RSS   

Site design: Giorgos Lazaridis
© Copyright 2008
Please read the Terms of services and the Privacy policy