Home     Contact     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science     RSS     Terms of services     Privacy policy  
   
 Home      Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science   


<< Back to INDEX

3D-Print your own hole measuring caliper cones
posted February 10 2015 19:11.07 by Giorgos Lazaridis




I use calipers extensively for may day-job and I know first hand how frustrating can it be when it comes to measure hole centers. Center to center or edge to center...
This instructable shows how to 3D-print your own caliper cones and make your life that much easier!
Click this link to go to the page

[Link]
 
Share



You might also like...


Playing the Eye of the Tiger with floppies [Hack]

An electronic gadget to silence loudmouths [Project]

One-Chip Sound Player [Project]

An amazing and powerful 6-cylinder Stirling engine [Project]

DIY Paper Clip Cellphone Holder [DIY]

Open Source Programmable Solar Battery Management System [Project]

Slow Dog Food Dispenser for the Gluttonous Dogs [Project]

DIY Small and Silent Air Compressor on the Cheap


<< Back to INDEX



Comments

  Name

  Email (shall not be published)

  Website

Notify me of new posts via email


Write your comments below:
BEFORE you post a comment:You are welcome to comment for corrections and suggestions on this page. But if you have questions please use the forum instead to post it. Thank you.


      

No comment yet...

Be the first to comment on this page!












 Contact     Forum     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science     RSS   

Site design: Giorgos Lazaridis
© Copyright 2008
Please read the Terms of services and the Privacy policy