Home     Contact     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science     RSS     Terms of services     Privacy policy  
   
 Home      Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science   


<< Back to INDEX

High Power LED Torch out of Spray Can [Project]
posted November 3 2014 17:58.07 by Giorgos Lazaridis




The Cree XLamp CXA1507 is a very nice piece of light source but requires 18 volts to light. Marco used the MCP1630 chip to boost the voltage from 5 AA batteries to get the required voltage. And then he use an empty spray can and lots of imagination to make a cool flash light!








Schematics and code in this link

[Link: Marco Franciosi]
 
Share



You might also like...


Single Resistor Adjustable LDO Voltage Regulator [Circuit]

Solar powered Stirling engine runs at 1000rpm [Project]

Joule Thief - And How It Works [Project]

Make your own liquid pump from PVC pipes [Project]

Digital audio amplifier with PLL synthesized FM radio [Project]

Six clever uses of aluminum foil [Life Hacks]

blueShift - An OpenXC LED Tachometer [Project]

Macgyver SMD Soldering Iron Adaptor [DIY]


<< Back to INDEX



Comments

  Name

  Email (shall not be published)

  Website

Notify me of new posts via email


Write your comments below:
BEFORE you post a comment:You are welcome to comment for corrections and suggestions on this page. But if you have questions please use the forum instead to post it. Thank you.


      

No comment yet...

Be the first to comment on this page!












 Contact     Forum     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science     RSS   

Site design: Giorgos Lazaridis
© Copyright 2008
Please read the Terms of services and the Privacy policy