Home     Contact     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science     RSS     Terms of services     Privacy policy  
   
 Home      Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science   


<< Back to INDEX

Rubber Band Launcher Mark I [Project]
posted November 6 2013 10:34.00 by spic0m




A rubber band launcher made from pieces of plywood, a cardboard box, cable ties, and screws.
Nothing fancy so far, but what's cool about it is that you can use your smartphone to control the launcher from a distance!

It's very easy to make. If you have two servos lying around, you can construct this too.




[Link: Annikken]
 
Share



You might also like...


The Picdump of the day #7 [5 Photos]

NiCd Battery Charger Circuit [Project]

Tooth Fairy Tooth Transport [Project]

Scanning Laser Exposer [Project]

Turn a Raspberry Pi Into an XBMC Media Center in Under 30 Minutes [Project]

The Amazing Randi talks about his own Horoscope [Skepticism]

Watches made in Brooklyn - A short video [Video]

How evolution shapes the geometries of life [Biology]


<< Back to INDEX



Comments

  Name

  Email (shall not be published)

  Website

Notify me of new posts via email


Write your comments below:
BEFORE you post a comment:You are welcome to comment for corrections and suggestions on this page. But if you have questions please use the forum instead to post it. Thank you.


      

No comment yet...

Be the first to comment on this page!












 Contact     Forum     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science     RSS   

Site design: Giorgos Lazaridis
© Copyright 2008
Please read the Terms of services and the Privacy policy