Home     Contact     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science     RSS     Terms of services     Privacy policy  
   
 Home      Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science   


<< Back to INDEX

1200W Flyback Driven Capacitor Charger [Project]
posted July 21 2014 14:00.35 by spic0m




This is a 1200W charger which uses a coilcraft GA3460-BL flyback transformer in conjunction with the LT3751 microchip. In theory it is capable of charging a 12000uF 400V capacitor in only a few seconds. The LT3751 microchip controls the charging of the capacitor and offers charging cutoff and safety features. The charger is powered by a 4s 2200mAh Li-Po battery pack capable of 20c continuous discharging. This supplies the charger with 740 watts of power.


[Link: Polakium Engineering]
 
Share



You might also like...


Arduino Wireless Notice Board [Project]
Raspberry Pi Temperature & Humidity Network Monitor [Project]
Replacing the room lighting with LEDs [Project]
engravR (RPi Laser Engraver) [Project]

Eyeball Animation is Freaky! [Project]
Simplest DIY Distilling Equipment Ever to Clean Your Water
Simple home automation with Arduino and Raspberry Pi [Project]
DIY Small and Silent Air Compressor on the Cheap


<< Back to INDEX


Comments

  Name

  Email (shall not be published)

  Website

Notify me of new posts via email


Write your comments below:
BEFORE you post a comment:You are welcome to comment for corrections and suggestions on this page. But if you have questions please use the forum instead to post it. Thank you.


      

No comment yet...

Be the first to comment on this page!









 Contact     Forum     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science     RSS   

Site design: Giorgos Lazaridis
© Copyright 2008
Please read the Terms of services and the Privacy policy