Home     Contact     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science     RSS     Terms of services     Privacy policy  
   
 Home      Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science   


<< Back to INDEX

Make this 3D-printed cornstarch flamethrower for the zombie apocalypse
posted January 13 2015 20:13.34 by Giorgos Lazaridis




I am not quite sure how effective this DIY cornstarch flamethrower will be against hungry zombies, but it definitely works well against paper zombies... Ivan Owen made this one with 3D printed parts and a battery-powered leaf blower. Well... I'm still very skeptic...



[Link]
 
Share



You might also like...


32 channel mains lamp controller [Project]

blueShift - An OpenXC LED Tachometer [Project]

Very basic and Simple Line Following Robot Without a Microcontroller [Project]

Arduino Solar Panel Battery Charge Controller [Project]

Tie Tying Machine [Project]

LED Resistor Dial Selector [Tools]

Impact, Vibration and Ultrasound Sensing with PVDF Piezo Sensors [Project]

Connector-less ICSP probe housed in pen [Project]


<< Back to INDEX



Comments

  Name

  Email (shall not be published)

  Website

Notify me of new posts via email


Write your comments below:
BEFORE you post a comment:You are welcome to comment for corrections and suggestions on this page. But if you have questions please use the forum instead to post it. Thank you.


      

No comment yet...

Be the first to comment on this page!












 Contact     Forum     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science     RSS   

Site design: Giorgos Lazaridis
© Copyright 2008
Please read the Terms of services and the Privacy policy