Home     Contact     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science     RSS     Terms of services     Privacy policy  
 Home      Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science   

How to make a professional-like panel labelAuthor
Peter Boston
May 15, 2012

PAGE 2 of 2 - Laminating

Place the printed label into a laminating pouch and insert into a laminator.

Pouch and Label
Inkjet label

Ready to laminate
label in pouch

Trim the laminated label to size
Partially trimmed label

Completed label before punching holes
Ready for holes

Label after holes punched
Completed label

Glue label to the panel of your project.
First attempt

I used contact adhesive, but I discovered a few text errors so I replaced the label, the glue had melted part of the plastic case, so I should have checked the solvent in the glue against the plastic the box was made of.

Another method of sticking the label to the panel is to smear it with a thin coat of neutral cure silicone.

Continue reading. Click here to go back to the first page <<<.



  Email (shall not be published)


Notify me of new posts via email

Write your comments below:
BEFORE you post a comment:You are welcome to comment for corrections and suggestions on this page. But if you have questions please use the forum instead to post it. Thank you.


  • At 21 May 2012, 16:37:05 user Pantelis wrote:   [reply @ Pantelis]
    • the 1st solution is very expensive, the second is the best, i sent an email to http://www.officeworks.com.au/retail/content/Home to sent me the laminator Lowell 280 but the sait is in Australia and they cannot sent it to Greece ,what a pity!!!

  • At 21 May 2012, 13:28:12 user George wrote:   [reply @ George]
    • Standard laminators do not get hot enough for toner transfer, HOWEVER there are a few guides online that show how to modify "some" laminators for transfer method.Refer to pcbfx.com (they sell toner transfer products, and have some guides for modifying laminators, and also there is a mod guide on ultrakeet.com.au.




  • At 21 May 2012, 12:51:52 user Pantelis wrote:   [reply @ Pantelis]
    • Hi, very nice work, do you know if this laminator is suitable for using it as hot laminator that push the printed pcb laser paper to the pcb, because the method with the uv lamps and photo resisted pcb is expensive for me

    reddit this Reddit this

     HOT in heaven!

    NEW in heaven!

    New Theory: AC electric motor working principle

     Contact     Forum     Projects     Experiments     Circuits     Theory     BLOG     PIC Tutorials     Time for Science     RSS   

    Site design: Giorgos Lazaridis
    © Copyright 2008
    Please read the Terms of services and the Privacy policy