PAGE 2 of 2 - Laminating
Place the printed label into a laminating pouch and insert into a laminator.Pouch and Label
Ready to laminate
label in pouch
Trim the laminated label to size
Partially trimmed label
Completed label before punching holes
Ready for holes
Label after holes punched
Glue label to the panel of your project.
I used contact adhesive, but I discovered a few text errors so I replaced the label, the glue had melted part of the plastic case, so I should have checked the solvent in the glue against the plastic the box was made of.
Another method of sticking the label to the panel is to smear it with a thin coat of neutral cure silicone.
|At 21 May 2012, 16:37:05 user Pantelis wrote: [reply @ Pantelis]|
the 1st solution is very expensive, the second is the best, i sent an email to http://www.officeworks.com.au/retail/content/Home to sent me the laminator Lowell 280 but the sait is in Australia and they cannot sent it to Greece ,what a pity!!!
At 21 May 2012, 13:28:12 user George wrote: [reply @ George]
Standard laminators do not get hot enough for toner transfer, HOWEVER there are a few guides online that show how to modify "some" laminators for transfer method.Refer to pcbfx.com (they sell toner transfer products, and have some guides for modifying laminators, and also there is a mod guide on ultrakeet.com.au.
At 21 May 2012, 12:51:52 user Pantelis wrote: [reply @ Pantelis]
Hi, very nice work, do you know if this laminator is suitable for using it as hot laminator that push the printed pcb laser paper to the pcb, because the method with the uv lamps and photo resisted pcb is expensive for me
HOT in heaven!